ToME: the Tales of Maj'Eyal

I'm working on pushing an update for the main git version, but despite a certain talent working as an addon, when I made direct changes to the git it now fails with the following error:

==============================================
[LOG] Player casts Drain.
[SPELL CRIT %] 1
stack traceback:
[C]: in function 'error'
/engine/interface/ActorTalents.lua:153: in function </engine/interface/ActorTalents.lua:135>
Lua Error: /engine/interface/GameTargeting.lua:118: /engine/interface/ActorTalents.lua:153: /engine/Entity.lua:133: Entity definition has a closure: Entity closure checker: value[info] has upvalue info
stack traceback:
[C]: in function 'error'
/engine/Entity.lua:133: in function 'init'
/engine/Projectile.lua:37: in function 'init'
/mod/class/Projectile.lua:29: in function 'init'
/engine/class.lua:97: in function 'new'
/engine/Projectile.lua:288: in function 'makeProject'
/engine/interface/ActorProject.lua:321: in function 'projectile'
/data/talents/corruptions/sanguisuge.lua:36: in function </data/talents/corruptions/sanguisuge.lua:32>
[C]: in function 'xpcall'
/engine/interface/ActorTalents.lua:148: in function </engine/interface/ActorTalents.lua:135>
At [C]:-1
At [C]:-1 error
At /engine/interface/GameTargeting.lua:118 fct
At /engine/interface/GameTargeting.lua:124 targetMode
At /engine/interface/GameTargeting.lua:253 targetMouse
At /mod/class/Game.lua:2019 fct
At /engine/Mouse.lua:56

This appears to occur whenever I try and target a spell. The above was from casting Drain, and the below happened on a Necromancer when I cast Invoke Darkness:

Lua Error: /engine/interface/GameTargeting.lua:118: /engine/interface/ActorTalents.lua:153: /engine/Entity.lua:133: Entity definition has a closure: Entity closure checker: value[target] has upvalue isFF

Not sure where to even begin here, any ideas?

That's kinda my fault. I put some stricter checks for upvalues in. There's a fix that darkgod hasn't accepted yet.

It should work fine if you turn debug mode off, though.

Good to know! I'll just wait till that fix goes in and push my changes then, thanks.